Loose pages are bound using hot adhesive to a wraparound cover, resulting in a standard paperback with a square spine. This economical method of binding works with a variety of papers. Covers can be printed one or both sides. In addition, the outside cover can be UV coated or laminated to increase durability and improve appearance. After binding, the book is flush-trimmed on three sides.
We can bind sizes from 4"x5" up to 12"x18" and any thickness up to 3" with some limitations.
For a sucessful binding, the paper grain of both the cover and pages need to run parallel to the spine. Glue will not adhere to printed or varnished surfaces.
Loose pages (no folds) need to be supplied stacked in order and separated in books. Pages should be oversize by 1/8" top, bottom and leaf side to allow for three-side trim. The spine side will not be trimmed (no grind-off).
Covers need to be supplied flat. Be sure to allow for spine thickness and bleed margins. Grain must run parallel to the spine!
No job is too small for us! We specialize in fast service for small quantities. However we do have a minimum charge of $25.00, which applies to all invoices.
All jobs are subject to quotation, but here are some guidelines:
We can bind approximately 10 softcover books for $25.00
Runs of up to 25 books are priced at $2.50 each.
25-50 books - $2.25 ea.
50-100 books - $2.00 ea.
Above pricing based on letter-sized or smaller books with spine thickness of 1/2 " or less. Larger sizes and quantities are available.